Evolution-engines NX Evolution Manuel d'utilisateur télécharger pdf (Page 5)

How to tell if your glow plug is bad

The glow plugs on the market today are designed

to provide good service to the user and may last a long

time or a short time, all dependent upon the way you

choose to operate your engine.

Physical indications that you might need to

change the glow plug are:

1. Twisted or mangled glow plug element (usually

caused by too high a compression ratio).

2. Small “bumps” are attached to the glow plug

element. This will generally be most noticeable

during the break-in process. These are actually

tiny pieces of aluminum that have attached to the

element and these will severely hinder the operation

of the glow plug.

3. The glow plug element is no longer shiny but is dull,

almost a white powder color. (This just comes with

age and is a by-product of the catalytic reaction.

The shinier the wire, the better the catalytic reaction

can be).

Operating indications that you need to change

your glow plug are:

1. The glow element will not light with a charged glow

igniter. This indicates that there is a physical short

or breakage in the element wire itself.

2. Glow plug lights but the engine will not continue

running once the battery is disconnected. (This is

usually an indication of the microscopic particles

we discussed earlier).

3. Glow plug lights, engine runs but there is a

perceptible loss of rpm at full throttle when the

battery is disconnected. This is a typical indication

that the white powder residue is building to the

point that the catalytic reaction of the glow plug is

no longer anywhere close to being optimum.

Troubleshooting Guide

Engine Won’t Fire

• Glow starter not charged

- Charge glow starter

• Glow plug burnt out

- Replace glow plug

• No fuel is getting to the carburetor

- Check tank, fuel lines reversed

• The starter is reversed

- Reverse the polarity on the starter cables

Engine Quits Repeatedly

• Needles need adjusting

- See adjustment procedure

• Bad or old fuel

- Replace with fresh fuel

• Worn out glow plug

- Replace with new HAN3006 super plug

Engine Runs Inconsistently

• Hole in fuel line

- Replace fuel line

• Bad or old fuel

- Replace with fresh fuel

Maintenance

After each flying session:

1. Fully drain the fuel from the tank.

2. Start the engine and run it until the fuel is

completely run out of the engine.

3. Try starting the engine three more times or until

it will no longer fire. This gets all the fuel out of

the engine.

If the engine will not be used within 10 days, several

drops (about 10) of after run oil (Evolution Engine's

Blue Block Rust Inhibitor) should be applied into the

carburetor and the engine should be turned over for

a few seconds with the starter. This will prevent rust

and corrosion.

If you need additional help or have any questions, please call

Horizon’s Service Center. Horizon has trained technicians who

are qualified to answer your engine questions.

Evolution/Horizon Service Center

4105 Fieldstone Road

Champaign, IL 61822

877-504-0233

Disp Bore Stroke Weight Crank K

Items (c.i.) (mm) (mm) (oz) (ISO) Cylinder Propeller

EVOE0360 .354" .806" .695" 10.3 1/4X28 ABC 9X6

EVOE100 .455" .867" .771" 16.32 1/4X28 ABC EVOE100P

EVOE0400 .392" .805" .771" 14.08 1/4X28 ABC 10X6

EVOE0460 .467" .864" .797" 13.76 1/4X28 ABC 11X6

EVOE0520 .520" .882" .847" 14.72 1/4x28 ABC 11X6

EVOE0610 .608" .944" .862" 20.1 5/16 X 24 ABC 12X6

EVOE1100 1.005" 1.14" .985" 23.2 5/16X24 ABC 14X6

NT/NX Evolution

Engines Specifications

Dimensions(mm) A B C D E F G H

EVOE0360 30 38 15 47 78 108 1/4X28 37

EVOE100 36 44 17.5 52.5 90.5 108 1/4X28 37

EVOE0400 36 44 17.5 52.5 90.5 108 1/4X28 37

EVOE0460 36 44 17.5 52.5 90.5 108 1/4X28 37

EVOE0520 36 44 17.5 52.5 94 110 1/4X28 37

EVOE0610 42 55 25 55 100 133 5/16x24 42

EVOE1100 44 52 25 64.6 92 139.7 5/16x24 42

E = height

F = length

G = crankshaft thread size

H = muffler bolt spacing

Evolution

Engines 2-Year Warranty

This Evolution Engines product is guaranteed to be

free from defects in materials and workmanship

for a period of 2 years from the date of purchase by

the original owner. This warranty is not transferable.

Horizon Hobby reserves the right to inspect any and

all equipment involved in a warranty claim. Repair or

replacement decisions are also determined by Horizon

Hobby, Inc. Collateral damage of any type is not

covered under this warranty.

This warranty does not cover any component parts

damaged or changed by modification. In no case shall

Horizon Hobby or Evolution Engines liability exceed the

original cost of the engine.

This warranty does not apply to wear from normal use;

damage or defects resulting from misuse, neglect or

abuse; damage caused by customer disassembly,

use of substandard fuel, use of incorrect accessories

(spark plug, propeller, etc.); or damage resulting

from a crash, or any use of this engine other than for

which it is specifically intended. Any of the above will

automatically void the warranty of the engine.

In that Horizon Hobby has no control over the final

installation and use of this product, the materials used

in installation, or the product in which this engine is

installed, no liability shall be assumed nor accepted for

any damage resulting in the use of this product once it

is installed. By the act of using the installed product,

the user accepts all resulting liability. If the buyer is

not prepared to accept the liability associated with

the installation and/or use of this product, the buyer is

advised to return the engine immediately in new and

unused condition to the place of purchase.

Should your engine require warranty or non-warranty

repair service, please package it carefully and return it

to the address below, along with a copy of the original

invoice or receipt and a detailed letter explaining the

problems. Write your name, address and daytime

phone number clearly on the letter and return it via

FedEx, UPS or insured Parcel Post (Evolution Engines

will not be responsible for product lost en route).

For repairs not covered under warranty, please specify

in your letter whether you want an estimate of the

repair charges prior to performing the service (which

may cause a slight delay). Payment for non-warranty

repairs should be made by credit card or money order.

If you have any questions concerning this or other

Evolution products please contact the Horizon Product

Support Team at 877-504-0233.

Evolution/Horizon Service Center

4105 Fieldstone Road, Champaign, IL 61822

877-504-0233

productsupport@horizonhobby.com

9155_EVO(NTAirManualUpdate).indd8-9 8-9 6/2/06 3:41:19 PM

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Evolution-engines NX Evolution Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Evolution-engines NX Evolution