Evolution-engines EVOE33GX Manuel d'utilisateur télécharger pdf (Page 5)

EN

5

Throttle

Arm

Rail-mount Installation

1. Remove the 4 screws which attach the

rear-mount.

2. Remove the rear-mount and replace the 4

screws with the shorter M3 screws included

with this engine.

3. Secure the engine mount on the airplane

ﬁrewall. Tighten the engine mount screws

in the ﬁrewall.

4. Install the engine on the engine mount

according to the airplane manufacturer’s

instructions.

Rear-mount Installation

1. Secure the engine to the airplane ﬁrewall

using either M5 or 10-32 bolts. Use spacers

or standoffs as needed to set the correct

ﬁrewall-propeller distance according to the

airplane manufacturer’s instructions.

WARNING: Tighten all engine

mounting screws before each ﬂight. If

you do not tighten the engine

mounting screws, the screws may

vibrate loose and cause the engine to

separate from the fuselage.

Included Content

ENGINE

• Mufer (EVOG33601)

• Mufer Screws & Gasket (EVOG33100A)

• Spark Plug (EVOG33350)

• Evolution/Spektrum

™

Telemetry RPM

Adapter Cable (EVOA107)

• Large Gas-FKM Fuel Tubing (EVOA109)

• Large In-line Fuel Filter (EVOA111)

• Large In-tank Felt Filter/Clunk (EVOA112)

OPTIONAL ITEMS

• Tachometer (HAN156)

• Propeller 17 x 8 (APC17080) for break-in;

18 x 8 (APC18080) for normal ight

• Optical Electronic Ignition Kill Switch

(EVOA100)

• Evolution Synthetic 2-Cycle Oil, (EVOX1001Q)

• Ultra Fuel Pump (HAN155)

Mufﬂer

Spark Plug

Fuel Nipple

High-Speed

Needle

Choke Arm

Low-Speed

Needle

Installing the Engine

1 2 3 4 5 6 7 8 9 10 ... 18 19

Commentaires sur ces manuels

Pas de commentaire